I am not a huge black Friday person. I usually find one thing thats a great deal, wake up, go get it and come right back home. Last year I got a 16 gallon 6 hp shop-vac from Menards for $39.99 :) This year I decided to hit up Sears at 4am....

Hello. If I'm not mistaking the 03/04 Mustang Cobra shift knob has a 12mm X 1.75 thread pattern but I was wondering how long the tip of the stick has to be machined down to accept the Knob ? I bought a knob and had it shipped to Florida and now...

We have a 2000 Camaro that only has 55,000 miles on it and has time slips for 9.92 and a 9.94 1/4 mile at 136 mph. This car is street legal and is straight, undamaged, clean titled, and a real beauty. Car is professionaly dyno tuned. On motor it put...

Hey guys, I've been looking up some prices for machining. I'm not sure of many of the prices for getting any type of machining done to an engine. Yesterday afternoon I approached a machine shop I found hidden in the back roads near my job. I spoke with...

When the subject of 4-link is brought up, most never think about the Mustang. The Fox body rear suspension is a 4-link, albeit a little different from the typical aftermarket design. The lower links angle slightly inward and the upper links are...