Editor reviews are provided by professional editors who evaluate a blog based on the following criteria: Frequency of Updates, Relevance of Content, Site Design, and Writing Style.
Still after many years no one has taken the very simple and often published point of ours that rocker is never defined in the surf industry ( except in our camp it seems ) by actual rates of curvature. Rates of curvature are the only way to compare...
Discussion of downrails nearly always winds up focusing on the part of the rail below the turn, and usually does so without any reference to the actual radius of the rail below the turn.
Focusing on the lower part of the rail is to be expected of...
Answer to a question regarding the use of 3mm wide frames in the parallel profile surfboard construction system:
3mm or 4mm is thinner than I'd use unless the frame junctions are tied with vertical struts, as it will reduce the glue contact area at...
Here the mid section of the panel which was glued yesterday is ready for the nose components and most of the tail. The tail will be done in two sessions to avoid creep.
Mixing 100mls of resin at a time, about 700 to 800mls are required for the...
Internal frame panel #1 this one will support the deck
After laying out the blocks and frames for the middle section of the panel, we secure the frame and blocks at one end of the section we are about to glue together, and then pull the rest of the...