... changed out for the OEM stuff. The service manager said that since they are going to put in a new clutch the gear oil gets changed anyway so it wouldn't be a separate charge. :D Perhaps that means that you have to drain and remove the transmission to access the clutch. Does anyone know if that's true or what other reason there would be that required draining the transmission in order ...

... when engaging 1st from stand still it doesn't jump right into gear. Sometimes it feels like it's only half-engaged - won't ... gets tricky to engage 1st gear in a Prelude so I usually put in 2nd gear and than in 1st. But now I seeing this hesitation also in 2nd. ... smooth. Also - the car has about 100.000miles and I can see master clutch cylinder is a bit moist (insede of the firewall) ...

... next shopping site.Went in for a hour or so.Came out and push in clutch to start and it jumps like in gear with no clutch pedal engaged.Long story short, ... area to install and haul it to do it.Also has exhibited hardly any slipping ever except in higher gear with much throttle and when trying to leave last not pedal went to floor and never did that before so that is why I think it is hydraulic,but ...

... year, will feature Alfa Romeo's six-speed twin-clutch automatic transmission. Since its launch in Australia last July, the MiTo has ... five- and six-speed manual transmissions only. The new gearbox uses two gear sets, each with its own clutch, allowing the gearbox to select the next required gear while the previous gear is still engaged. “While the Alfa Ro... Read more

... have been riding around. But just a couple days ago his engine wouldn't start or "turn over. When i would pedal with the clutch lever on my handlebar out it wasn't catching. So I took off the clutch cover and sure enough the large gear won't spin. It will if I go very very slowly and help it alone with my fingers. So... I'm ...

Hello , recently my car has been making some weird noises...first one is when my clutch is not engaged it makes a rattling sound coming from the tranny. i think that is my throw out bearing if im not correct....now second, when i go into first gear driving it clicks...maybe my axles??? in every gear the transmission whines throughout the gear... any ideas? any help would be appreciated.

... lean-against-a-tree method!) as it was oil change time anyway. This is what you see after removing the clutch casing The first thing to look out for is the elusive and very important “wavy washer” ... to adopt Mikeinva’s method of sitting on the bike, putting it in gear and standing on the back brake. Now without the bike falling over, heave on ...

... you guys take off hard, fast, BUT SMOOTHLY? if i stab the pedal i get a jerky take off until the clutch fully engages i'm under hard acceleration, but the first few ... can also play with the pedal starting slow and then pressing down faster while the clutch is engaging and sometimes i get a quicker engage and take off but sometimes it goes back to jerky bucking until fully engaged also ...

... bought a 91 NA Supra which has 187.5k on it and the clutch is slipping in first. I am going to replace it and the mechanic is going to charge as much as $850 for the(clutch disc, throwout bearing, pilot bearing, pressure plate, resurface the flywheel, replace tranny mount ... is a good price? Also, another question- when driving in 5th gear the rpm are over 3k @70mph-is this normal? I'm ...

Hi, Basically, My bike is trying to drive forward once it has been knocked into 1st gear. It idles, i pull my foot under the shifter up, and pull up the shifter. Nothing happens now, but when i then release the shifter, and it shifts into 1st gear, the bike tries to roll forward. Is this normal? Is there a way i can stop it? Thanks a lot! Luke :)

... in first and it hangs in second, the light turns and I can't get going unless I feather the clutch to start in second. If I have time at the light I can mess with the throttle and let out on the clutch and I can work it down to first or neutral. It just seems that the gears aren't quite meshing. If I do my down shifting as I'm coming to a stop and get it to neutral before a stop I ...

... to drive somewhere a bit later, and insied the cab smells like gear oil, and I did not see any visible leaks from under the car, so fine I ... before home, a clicking noise started to appear from the passenger side of the motor, and when in first gear only, the clicking accelerated with the car, ... 500 miles ago, recently adjusted clutch (improperly, gonna do that too), and the slave cylinder rubber ...

... gearbox in the R8 haven’t received favourable reviews, so Audi has developed a twin-clutch, seven-speed ‘box for the RS5, which was specially reinforced to accommodate the high-revving V8. ... RS models, the RS5 comes with quattro permanent all-wheel drive, but the self-locking crown-gear center differential is a new development. It’s compact, light and attains a high efficiency ratio ...

I only got to know that OS Giken has released the Super Single clutch for 4G92/93 engines few days ago. After doing some checking and it seems ST Wangan has brought them ... clutches, im crossing my fingers and hopefully they bring some aggressive Tomei camshafts for 4G92 Mivec and also OS Giken gear ratios and final drives for the 4G92/93 gearboxes. If they plan to hit the Malaysian market and also ...

Hi i noticed today that when i put my bike in gear at a stop with the clutch in it trys to pull. Its dosnt pull hard but just enough you have to pull the front brake. Is there any quick fix for this. Like the numbered dial on the lever. Im not sure what that does but any help would be appriciated.